Does opnsense not let you put vlan's into ospf?

Started by loganx1121, September 22, 2020, 05:05:46 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions
September 22, 2020, 05:05:46 AM
I have 2 port LAG going from the fw to a cisco switch that has 6 Vlans running over it. All the .1's for the Vlans are on the firewall. I can't seem to get the firewall to advertise any of the Vlan networks over ospf.

I have a L3 LAG running from the firewall to the cisco switch, and that advertises fine. Just wondering what the deal is.
September 22, 2020, 09:21:04 AM #1
Did you check interface and network tabs in OSPF config? Everything fine? Config?
September 22, 2020, 06:22:23 PM #2
Got it to work by setting network type to "Point to multipoint"
September 22, 2020, 06:30:20 PM #3
Actually if you do point to multipoint, you only get a route for the .1 of the vlan that lives on the firewall, so I went with broadcast which adds the entire /24 to the ospf routing table
September 22, 2020, 07:02:36 PM #4
NBMA should be used in usual networks
September 22, 2020, 08:00:33 PM #5
Quote from: mimugmail on September 22, 2020, 07:02:36 PM
NBMA should be used in usual networks
NBMA for Ethernets? Could you explain?

Thanks,
Patrick
Deciso DEC750
People who think they know everything are a great annoyance to those of us who do. (Isaac Asimov)
September 22, 2020, 08:37:53 PM #6
No, because it's nonsense, I mixed this .. sorry. :)
Print
Go Up Pages1
User actions