Wireguard Mullvad & roadwarrior

[nobody0]

I’ve successfully setup mullvad with wireguard from comments in this post https://forum.opnsense.org/index.php?topic=15105.0.

1. Create local instance with Mullvad settings, tick "Disable Routes" and under Advanced set Gateway "1.2.3.4"
2. Create endpoint (0.0.0.0, 1.2.3.4)
3. Link endpoint in local instance
4. Assign an Interface to WG, no IP config and lock it
5. Go to System : Gateways : Single, create a gateway, Interface WG, IP address of gateway 1.2.3.4, tick "Far Gateway"
6. Go to Firewall rules and set the stuff you want with gateway of WG.

Now I’m trying to get a tunnel setup and have multiple endpoints to access my network from the internet. I was only successful with getting one endpoint to connnect. Adding another one didn't work.

Has anyone successfully set this up yet? I changed the local listen port as I’m using 51820 for Mullvad and port forwarded that port to my wan address > lan opnsense ip. I can see the peer in list configuration and a few KiB of traffic received and sent.. but the handshake doesn’t seem to be completed.

I’ve been at this too long. If someone could share how they have working.. I promise there will be a reward.

Thank you!