problem with OpenVPN connection

[Gandalf123]

Hello to all,

sorry for my bad English, normaly i post the treads in the german forum section.

I have a OPNsense 19.1 and i will use the OpenVPN road warrior. After the configuration  my Windows Client is not able to establish a connection. Yesterday i have tried to find the error, but after 4 Hours i have give up. Today with the new Update the error is not the same, but iam not able to establish any Connection. Ist this a Problem from OPNsense 19.1 or ist the Problem my Windows Client or my configuration?

Thank you
Gandalf123

[tbandixen]

Is your Hostname and Port on the Client Export page correct?
It seams, that you left the internal ip in there, and port 443 is that correct for your setup?

[Gandalf123]

i have tested first the Configuration on my productive System, this is behind a Lancom router, and there was not work.
then i have installed another Opnesnese 19.1 in my Virtual lab for testing, and also i cannot connect me. The Wan IP in my Lab is an internal ip. I have no more ideas with the Problem. I have disabled the block private adresses on the Wan interface, and i have added the rule on the Wan side. Also a allow all on the openvpn interface.

best regards
Gandalf123

[marjohn56]

There are a few issues with openvpn on in 19.1 . There is an update release 19.1.1 which addresses these and other issues planned for release in the next day or so.


Edit.. it appears it's been released.

[Gandalf123]

i have installed the update today, but the problem persist. The export is now working fine