OPNsense Forum
Archive => 19.1 Legacy Series => Topic started by: Gandalf123 on February 05, 2019, 04:34:38 pm
-
Hello to all,
sorry for my bad English, normaly i post the treads in the german forum section.
I have a OPNsense 19.1 and i will use the OpenVPN road warrior. After the configuration my Windows Client is not able to establish a connection. Yesterday i have tried to find the error, but after 4 Hours i have give up. Today with the new Update the error is not the same, but iam not able to establish any Connection. Ist this a Problem from OPNsense 19.1 or ist the Problem my Windows Client or my configuration?
Thank you
Gandalf123
-
Is your Hostname and Port on the Client Export page correct?
It seams, that you left the internal ip in there, and port 443 is that correct for your setup?
-
i have tested first the Configuration on my productive System, this is behind a Lancom router, and there was not work.
then i have installed another Opnesnese 19.1 in my Virtual lab for testing, and also i cannot connect me. The Wan IP in my Lab is an internal ip. I have no more ideas with the Problem. I have disabled the block private adresses on the Wan interface, and i have added the rule on the Wan side. Also a allow all on the openvpn interface.
best regards
Gandalf123
-
There are a few issues with openvpn on in 19.1 . There is an update release 19.1.1 which addresses these and other issues planned for release in the next day or so.
Edit.. it appears it's been released.
-
i have installed the update today, but the problem persist. The export is now working fine