Home
Help
Search
Login
Register
OPNsense Forum
»
English Forums
»
Virtual private networks
»
no wiregaurd interface to select
« previous
next »
Print
Pages: [
1
]
Author
Topic: no wiregaurd interface to select (Read 1054 times)
memnoch_proxy
Newbie
Posts: 4
Karma: 0
no wiregaurd interface to select
«
on:
February 06, 2024, 05:37:16 am »
I have installed the wireguard and wireguard-go modules. I'm using OPNsense 23.7. I have created and Local and Endpoint configuration. However, under Interfaces I only have an OpenVPN interface free and no Wireguard interface listed. This system was using OpenVPN previusly back in versions 14-20, but I do not want to operate an OpenVPN peer anymore.
How do I proceed to get WG working on this system?
Logged
newsense
Hero Member
Posts: 1036
Karma: 77
Re: no wiregaurd interface to select
«
Reply #1 on:
February 06, 2024, 06:21:21 am »
Start by installing or upgrading to 24.1
Logged
memnoch_proxy
Newbie
Posts: 4
Karma: 0
Re: no wiregaurd interface to select
«
Reply #2 on:
February 06, 2024, 06:39:34 am »
I don't mind upgrading to 24.1. Do I correctly infer that there are WG related bugs in v 23?
Logged
newsense
Hero Member
Posts: 1036
Karma: 77
Re: no wiregaurd interface to select
«
Reply #3 on:
February 06, 2024, 06:42:21 am »
A lot of changes, and 24.1 is the currently supported one.
You can read all about it in the Announcements board
Logged
jmcgee
Jr. Member
Posts: 50
Karma: 1
Re: no wiregaurd interface to select
«
Reply #4 on:
February 06, 2024, 04:54:37 pm »
OPNsense 24.1_1-amd64
Logged
jmcgee
Jr. Member
Posts: 50
Karma: 1
Re: no wiregaurd interface to select
«
Reply #5 on:
February 06, 2024, 04:57:43 pm »
I have same problem, I suspect it is because I can't get the Zerotier Network enabled. Can you ?
Logged
memnoch_proxy
Newbie
Posts: 4
Karma: 0
Re: no wiregaurd interface to select
«
Reply #6 on:
February 07, 2024, 04:54:39 am »
@jmgee sorry, I might get a chance to check on ZT after I focus on present conundrum.
Logged
memnoch_proxy
Newbie
Posts: 4
Karma: 0
Re: no wiregaurd interface to select
«
Reply #7 on:
April 15, 2024, 12:59:39 am »
I have updated system to OPNsense 24.1.5_3-amd64.
I can see packets leave my cloud host over the private network (10.4.6.0/23) but I do not see them in OPNsense when I tcpdump wg1. I have opened the firewall for the WG port. My firewall is behind a Comcast modem and it has a 10.1.10 address. Could I be seeing these problems because the Comcast modem is blocking my WG port?
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
English Forums
»
Virtual private networks
»
no wiregaurd interface to select
