23.1.11 and zeroteier interface

[crankshaft]

I updated to 23.1.11 a few hours ago, and after the reboot, lost all WAN / Internet connections.

After spending some time looking at the logs and not seeing any errors, I disabled the zerotier interface and it all came alive again.

During reboot, if the zerotier interface is enabled, all outbound traffic is blocked, as soon as I disable the interface and reboot, everything is back to normal.

If the interface is disabled during boot, and I then manually enable it again after bootup, everything is ok, until the next reboot.

It may be a coincidence that this happened at the same time as the update, but the zerotier install was done a few months ago, and i've not seen any similar issues.

Interested to hear if anyone else is experiencing this or has any ideas on the cause or solution ?

[crankshaft]

I just uninstalled completely (including interface) rebooted, all was good.

I then reinstaled zerotier, setup the interface, confirmed that it was connected, and rebooted and same problem, no internet / wan.

So for me at least, zerotier is broken on 23.1.11

[franco]

Sounds a bit like zt snatching your default gateway traffic. I've had a similar issue yesterday testing a GUI change for WireGuard plugin but the test data I gave WireGuard lead to my normal traffic being dropped...


Cheers,
Franco

[SebbesApa]

I just uninstalled completely (including interface) rebooted, all was good.

I then reinstaled zerotier, setup the interface, confirmed that it was connected, and rebooted and same problem, no internet / wan.

So for me at least, zerotier is broken on 23.1.11

Did you downgrade or did you manage to solve it somehow?