Home
Help
Search
Login
Register
OPNsense Forum
»
English Forums
»
General Discussion
»
help with WAN IPv6 setup
« previous
next »
Print
Pages: [
1
]
Author
Topic: help with WAN IPv6 setup (Read 2091 times)
pixielark
Newbie
Posts: 9
Karma: 0
help with WAN IPv6 setup
«
on:
April 02, 2022, 08:49:01 am »
Hello everyone,
I am trying to migrate my baremetal box from pfsense to opnsense, but it looks like I cannot get my IPv6 working
Before for pfsense installation I followed the tutorial here
https://www.zacharyschneider.ca/2020/12/pfsense-ipv6-telus/
and was having my IPv6 working just fine.
But it looks like in the opnsense world "Do not wait for RA" got removed for whatever reason.
Does anyone know whats the equivalent in opnsense for this option right now?
All my LANs are just showing as track6 and none of them has v6 address assigned and none of my device can get v6 address through SLAAC
Also the "Do not allow PD release" option is not at the same location as pfsense, but I think the equivalent is at Interfaces -> Settings -> IPv6 DHCP -> Prevent release?
Thanks in advance
«
Last Edit: April 04, 2022, 08:11:54 am by pixielark
»
Logged
RamSense
Hero Member
Posts: 594
Karma: 10
Re: help with WAN IPv6 test up
«
Reply #1 on:
April 02, 2022, 11:11:33 am »
I used this tutorial to set it up:
https://homenetworkguy.com/how-to/configure-ipv6-opnsense-with-isp-such-as-comcast-xfinity/
maybe it is useful for you also.
Logged
pixielark
Newbie
Posts: 9
Karma: 0
Re: help with WAN IPv6 setup
«
Reply #2 on:
April 02, 2022, 12:36:29 pm »
Thanks a lot for the link.
So eventually IPv6 starts to work on my opnsense box without any config change, probably waited for like 20-30 minutes maybe?
I am curious if there is a way for opnsense to skip the wait (aka do not wait RA) so every reboot it will get v6 working right away
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
English Forums
»
General Discussion
»
help with WAN IPv6 setup