Disable Traffic Shaper

[Brent Dacus]

All: 

I searched and read lots of posts.  I set up guestnet shaping.  Now I want to remove it / disable.  So I removed all the rules, and pipe.  Applied even reset.  Then rebooted.  The connection is still limited?  What have I missed? 

[mimugmail]

Screenshots of Pipes please

[Brent Dacus]

all removed

[Brent Dacus]

As well the queues and rules. I removed them all. The system reports no limiter on system. However the speed test still shows 50 mbbits.  Even dumped the state tables and reboot the Mac as well.

[mimugmail]

And Status says nothing???

[Brent Dacus]

Could not find limiters on system..

[mimugmail]

What happens when you enable shaping again with 100mbit?

[Brent Dacus]

Ok when I can will try that. Strange that removing doesn’t work though. Thanks so far.

[mimugmail]

I'm sure WiFi or service provider is limiting to 50 or whatever. We'll see when you set to 100

[Brent Dacus]

You are absolutely correct. It’s not opnsense. It’s a bad firmware update by att. The have broken DMZ in the latest firmware. If I take it out of dmz mode works great.