OPNsense Forum

Archive => 18.7 Legacy Series => Topic started by: Brent Dacus on December 02, 2018, 07:04:28 pm

Title: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:04:28 pm

All: 

I searched and read lots of posts.  I set up guestnet shaping.  Now I want to remove it / disable.  So I removed all the rules, and pipe.  Applied even reset.  Then rebooted.  The connection is still limited?  What have I missed? 

Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 07:11:21 pm

Screenshots of Pipes please

Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:15:20 pm

all removed

Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:29:24 pm

As well the queues and rules. I removed them all. The system reports no limiter on system. However the speed test still shows 50 mbbits.  Even dumped the state tables and reboot the Mac as well.

Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 09:52:09 pm

And Status says nothing???

Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 11:01:53 pm

Could not find limiters on system..

Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 11:34:42 pm

What happens when you enable shaping again with 100mbit?

Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 03, 2018, 12:42:53 am

Ok when I can will try that. Strange that removing doesn’t work though. Thanks so far.

Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 03, 2018, 06:24:49 am

I'm sure WiFi or service provider is limiting to 50 or whatever. We'll see when you set to 100 :)

Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 06, 2018, 04:10:57 pm

You are absolutely correct. It’s not opnsense. It’s a bad firmware update by att. The have broken DMZ in the latest firmware. If I take it out of dmz mode works great.   8)