Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ooboyle

#31
And now it won't stay on for more than 5 minutes, it seems.
#32
To add to this, once the service stops, I need to reboot to get the engine to start again.
#33
Hi Bill,

Thanks for the quick response!

All hardware offloading is disabled.

There's currently 1GB RAM in this test environment with very little traffic. Is that insufficient?

Oliver
#34
Hi,

Love OPNsense so far and hope to deploy it to 70 sites in the next year but I'm having an impossible time getting Suricata to work. I'm running ESX 5.5 and using e1000 adapters on 3 interfaces.

OPNsense 16.1.14-amd64   
FreeBSD 10.2-RELEASE-p17   
OpenSSL 1.0.2h 3 May 2016
Latest updates are all applied

I've tried with vmxnet3 adapters as well and the service stops immediately. The e1000 adapters allow is to stay on for an hour or so before the service stops. Any change to the WAN interface (including firewall rules) causes Suricata to stop. After a reboot, the Suricata engine starts (as per the log file), but then no message is left when it stops after being left alone for a while.

Any ideas? Any assistance would be greatly appreciated.

Oliver