Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - pistolinux

#1
17.1 Legacy Series / OPNSense 17.1.4 stuck at boot
July 17, 2017, 04:30:16 PM
Hi, my name is Christian,
I'm trying to deploy an OPNSense VM on KVM (RHEL 7.2).
I tried all the installation supports (VGA, CDROM) both 32 and 64bit but the problem is the same:
The boot process stucks  after a few seconds with message: "Booting..." as you can see in the screenshot below:


How can I enable debug logs and increase verbosity for the boot?
I tried with vSphere 5.5 and VirtualBox and I was able to boot and install OPNSense correctly.
Though even if I exported the VM's disk (either in VMDK or VDI format) and converted it in QCOW2 (or RAW), the VM does not boot at all.

Thank you