Messages

1

General Discussion / Re: 2 Problems: IPsec and IPv6

« on: August 26, 2015, 03:18:08 am »

Cool, I'll be looking forward to 15.7.10 and future releases!

Thanks for all the help and explaining PowerD. 

2

General Discussion / Re: 2 Problems: IPsec and IPv6

« on: August 25, 2015, 03:19:47 am »

Rebooted and IPv6 was down. I rand that command...

Output read: OK

Tested and got 10/10.

Rebooted again and IPv6 went down.

On another note, I started to use PowerD on Adaptive and after about 2 hours it will put serious load on the CPU. 1.01, 1.14, 1.03... and the graph will read at 51%. I turn off PowerD and it goes back to a normal range.
Kinda weird, just thought I'd bring it up.

3

General Discussion / Re: 2 Problems: IPsec and IPv6

« on: August 22, 2015, 07:11:41 pm »

The error I get after a restart is:
opnsense: /usr/local/etc/rc.newwanipv6: rc.newwanipv6: Failed to update WAN[wan] IPv6, restarting...

After I restart I have to go to my WAN interface and turn off DHCP6 then turn it back on for IPv6 to work.

It then works perfectly fine. I get 10/10 on Comcast IPv6 test site.

I used the site, which you linked on twitter, to do my IPv6 setup:
https://www.kirkg.us/posts/setting-up-ipv6-with-opnsense-and-comcast/

4

General Discussion / 2 Problems: IPsec and IPv6

« on: August 22, 2015, 04:17:09 am »

Absoltuley love OPNsense!

But, after the recent update to 15.7.9 I get an IPsec error (openvpn/ipsec):
Warning: Illegal string offset 'enable' in /usr/local/www/vpn_ipsec.php on line 258
Warning: Illegal string offset 'phase1' in /usr/local/www/vpn_ipsec.php on line 287 Warning: Invalid argument supplied for foreach() in /usr/local/www/vpn_ipsec.php on line

Which in turn gives me a:
OPNsense has detected a crash report or programming bug

Now with IPv6, everything works great until I reboot. It will then disable IPv6 on all devices until I turn DHCPv6 on and off in the WAN settings.

I don't know if this is just something I'm doing wrong or a bug? Any help would be nice. Thanks!