Messages

1

15.7 Legacy Series / Re: KVM (oVirt) | Can ping public hostnames but can't browse

« on: August 21, 2015, 01:21:55 am »

Hello all again. Just figured out the issue. There are some compatibility issues with KVM's VirtIO nic and OPNsense, PFsense, and FreeBSD in general. When setting up nics in oVirt and any other KVM virtualization use nic type e1000 which is Intel's Generic Gigabit profile.

Don't forget to check out oVirt (ovirt.org) if you're looking for a fully open source alternative to ESXi, vSphere, & vCenter.

2

15.7 Legacy Series / [SOLVED] KVM (oVirt) | Can ping public hostnames but can't browse

« on: August 20, 2015, 11:35:26 pm »

Hello all.

I'm very new to OPNsense. Have a weird issue with default install.

I have an oVirt (ovirt.org) server hosted in a datacenter. I'm trying to setup OPNsense as a "cloud" firewall.

my OPNsense virtual machine is configured with two nics WAN + LAN.
My WAN is configured with a Public IP.
My LAN is configured as 10.0.255.254/16

I have a few other virtual machines configured with one NIC on each which resides on the LAN network.

As stated with the default install of OPNsense with Outbound NAT set to auto I can ping public hostnames such as google.com or yahoo.com but when using a web browser on the LAN VMs I cannot access the internet.

From LAN VMs
using command line
ping google.com > success
ping yahoo.com > success
ping 8.8.8.8 > success
ping 209.244.0.3 > success
telnet google.com 80 > network not reachable

using web browser
URL google.com > page not found
URL 10.0.255.254 > OPNsense web page

From OPNsense
using shell
ping google.com > success
ping yahoo.com > success
ping 8.8.8.8 > success
ping 209.244.0.3 > success
telnet google.com 80 > connected

Am I missing a setting? I not sure why addresses can resolve via command line but are not actually reachable with a browser or telnet.

Any suggestions would be much appreciated.