Messages

thanks!

@Patrick, I forgot: I get to the login page also if I write http://router_ip

Hello Patrick,
thanks for your help, but my problem is that the config (see my first post) should allow only https connections, but instead the router moves to an http connection, even if I type https://router_ip. Yes I force the connection and I get to the router login page, but in http...
The config of the router seems to be ok: I listen only on LAN port and only https is checked.
Ciao,
GL

Is there any way to get in touch with the develping team members? Perhaps I found some bug...
This is my first installation of OPNsense, before I was using pfsense and perhaps I switched on&off some parameters in some "specific" sequence that "activated" some bug, while exploring the configuration.
Pls help...
Thanks.
Regards,
GL

as promised, below the picture of what I get in the browser address bar, if I write https://router_ip and then I press enter

hello,
are different ports...
This is what I cannot understand...
Ciao,
G

Hello
thanks for your support. I am now in my job place, I can post the picture this evening.
Yes I saved and restarted the router as precaution before writing this post. The pictures have been taken after several restarts. I made several attemts to login with https and http, getting always the same behaviour as described below.
Basically what happens is that:
1) if I use https://router_ip then I get a message from the browser that the connection is not safe and, if I force to go on, I get in the address bar of the browser an https red with the "deleted" sign and then in the address bar appears http://router_ip with the router login page
2) if I type http://router_ip, I get the router login page
Thanks.
Regards,
GL

Hello,
pls find hereafter a picture of my configuration. I try to connect to webgui on https, but I am always switched on http.
I do not understand why...
Thanks for your kind help.
Regards,
GL