Messages

Hi,

I have managed to set an Intel AX200 m.2 card to work as STA for WAN but the issue is that is only connect via 802.11a (54Mbps). Since that OpnSense 25.7.x is based in FreeBSD 14.3 which support 802.11ac.  Is there anything have to do to enable that?.

https://www.freebsd.org/releases/14.3R/announce/

Hi,

Is there an example where when the wan link is down to execute a script.

Thank you.

Is the host "on the Internet" from which you are testing actually connected to the same network as the WAN interface of OPNsense? I.e. is there an Ethernet instead of a point to point connection between OPNsense and the uplink router? And you are testing from that network?

In that case: Firewall > Settings > Advanced >  Disable reply-to.

That fix it.  Thanks.

Yes, I am banging my head against the wall.  I came from pfsense, so I know this should work. 

I have create the rules and disable to bogon but still not able to access.   From the OpnSense LAN, I can access the SSH, Ping and HTTPs.

I have setup OpnSense 25.7 and I cannot figure out how to access from the Web UI via the WAN port from the internal lan.  I have create a SSH and HTTPS firewall rule in the WAN interface but still blocked.  I also cannot pin the IP of the OpnSense WAN (192.168.100.101).

Internet <-> Internal network (192.168.100.1/24) <->  OpnSense  <-> Opn Internal LAN (192.168.1.1/24)