Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - stamp1t

#1
Quote from: Patrick M. Hausen on September 12, 2025, 01:38:26 PMFirewall > Settings > Advanced > Disable force gateway
Thank you, but it didnt change anything
#2
Hello everyone,

Im very new to OPNsense.

My setup is as follows: i have my ISP router and in the subnet created by it there are multiple devices including my main pc (*) and a mini PC with 2 NICs and OPNsense installed which is supposed to be the router/firewall for my homelab. For now there is only a laptop behind the OPNsense router which i use to configure the firewall.

Now to the problem: I want to access the web GUI of OPNsense from my main pc (*) but i just can not get it to work.

I tried the following things:
  • i made sure the Web GUI listens to both LAN and WAN
  • in the interfaces tab I enabled that private IPs can access the WAN interface
  • i made a firewall rule as follows:
    • Action: Pass
    • Interface: WAN
    • Direction: In
    • Protocol: TCP
    • Source: Single host or network and then my ISP subnet
    • Destination: This firewall
    • Port range: HTTPS to HTTPS

Something I noticed is that when I try to access the web GUI from my main pc and watch the firewall logs at the same time, then I see that the packets are being passed (by the rule i created)

I hope someone could help me here, I would appreciate it a lot