Messages

Hi all -  I created a SurfShark Wiregaurd instance VPN.  The everything from opnsense to Surfshark is connected (the gateway shows up).  I have 2 aliases created (IPTV list - has all the IPTV URLs, and Clients -  has the IPs of clients that I want to connect to surfshark).   So I want to create firewall rules to push all traffic indented for the iptv list to this VPN connection.  So I figure that this would have to be an out rule? 
Interface=LAN
Direction= out
destinations: IPTV List
gateway= Surfshark_GW

and the other rule would be an in rule?
Interface=Lan
source=clients
direction=in
destination=any
gateway=SurfShark_GW

But this does not seem to work, everything is still going over the WAN

HI...that was the key, all I had to do was move it up to the top.

Yes, I have a VPN Interface.  I am using Surfshark VPN client setup.  If I change the gateway all traffic is sent to it.  I tried adding another rule to send only the source IP to the Gateway but it does not work.  Additionally, I am still trying to also figure out how to route all traffic specific destination IP to the firewall only.   On my previous firewall (Untangle - Rista), all I did was create a rule for destination IP=x.x.x.x route the VPN Gateway.   I am not sure what I am going wrong.

Hi all, Any help would be appreciated. I was finally able to setup my VPN to Surfshark. I am able to route all traffic from my LAN to the VPN. But I would like to do two things:

Route a client connected out the VPN (IP address 10.1.1.98 to go the VPN Gateway)

All traffic that is say to espn.com to go out the VPN gateway (any traffic from the LAN).  I plan on setting up a different VPN for this connection.

After the update and installing os-realtek-re ;  it found the quad network card.  I have to look at all the devices I reserved IPs for and the rules that I have setup and in sometime in July I will fully start using this instead of untangle.

It has a working Intel 1G port.

HI all,

I am looking to move from Arista to Opnsense soon.   I am running Arista on a i3 Dell Optiplex with 16 GB RAM and 128 SSD with a quad 2.5G nic (RTL8125).   I created a bootable USB with opnsense to see if it would work.  I ran the system in live mode, but it does not detect the quad nic, only the builtin Intel onboard network card.  I attached an USB Ethernet to see if I can install the drivers for the quad but no luck.   This is the card that I have https://www.amazon.com/dp/B09SS8GVHC?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1 (SI-PEX24077)   Does anyone know if this can work with Opnsense?  I