Messages

I see what I did, the issue was a lot simpler. I accidently put it in the Destination, when should have been in the Source

Ya but in this config only one rule is enabled. As they are almost duplicate rules. The rule with ANY works when enabled, the rule with IMAP alias's does not work when it is enabled, and the other is disabled

Is there an initial Outbound rule, example I tried this, and it lets everything out.

When I turn it off, and try allowing all out in the WAN Interface, nothing goes out. As if only the Manual Outbound Rule Section, only allows rules

Which would mean I'd have to create all my outbound rules in the NAT section, not the WAN interface

I haven't found a lot of literature of the Manual Outbound configuration on Opnsense

What I'm trying to figure out is, if I set the NAT to manual Outbound. Do I configure all the outgoing rules within the NAT/Outgoing
Or do I configure them in the WAN infterace for Outgoing?

Looking for configuration documentation on this

I configured OPNsense inside of Proxmox. Wasn't my first choice, as it should be outside of it. However this is my usecase.
I have a virtual IP going to the VM on the WAN, and an internal isolated Bridge on the Internal.

Everything seems to be working fairly well. However oddly enough. If I do a portforwards, it works fine. But if I create an alias for a specific subnet. The rule fails, and the Portforwards isn't working.

Trying to figure out what I am doing wrong.

On the attachment, the top rule works, the bottom does not