Messages

Hi,

I currently have two WireGuard instances configured, one is a VPN client (WireGuard/NordLynx), the other is a VPN server (WireGuard Road Warrior). Is there a way to route the traffic that comes in via the Road Warrior interface, out via the NordLynx interface/gateway?

I have tried changing the outbound NAT rule, tried adding the VPN server IP address to the VPN client alias host list, also tried configuring multiple different firewall rules, nothing seems to work. Any help would be greatly appreciated.

Apologies if I've got some of the terminology wrong, fairly new to all this...

Interface (wg0) is protected, security zone is set to custom (vpn).

I can see traffic on wg0 under Interfaces & Vlans. If I filter to see live sessions > connections, everything is showing as Device (none) and src hostname is the tunnel IP provided by NordVPN.

Interface IP is in the 10.0.0.0/8 block.

I used this guide to set up the VPN:

https://docs.opnsense.org/manual/how-tos/wireguard-selective-routing.html

Hi - complete newbie here!

I have configured WireGuard VPN (NordLynx) using multiple guides I found on various forums. VPN works fine, the one issue I have is that Zenarmor does not recognise the interface under devices. Currently all the traffic that is routed over the VPN is displayed as 'Device (none)'.

Is this expected behaviour? I have another WireGuard VPN tunnel configured to enable remote access into the network, this is captured fine in Zenarmor. The only difference I can see is that under VPN > WireGuard > Status this interface has a 'Name', the NordLynx VPN does not.

Any help would be greatly appreciated!

Thanks.