Messages

Yes, both. The default "Allow LAN to any rule" has "LAN net" as the source address - that's 192.168.1.0/30 in your case(?). You could change that to "any", or add additional rules for your subnets. You'll also need to add routes to those subnets on OPNsense, but your diagram suggests you've already done that?

192.168.1.0/30 exactly what kind of rule should I write for the network address can you give an example

In the topology shown in the picture, computers on vlan 10 and vlan 20 cannot access the internet. I can see the IP addresses of the computers in Live View, but they cannot access the internet. Do I need an additional rule or routing for this?

https://imgur.com/a/7neml0o

herkese merhaba aşağıdaki topoloji pfsensede gayet sağlıklı çalışıyor fakat opnsense geçtiğimde çalıştıramadım
ip firewalla kadar geliyor loglardan görüyorum ama vlan10 ve vlan20 deki bilgisayarlar internete çıkamıyor
yorumlarınız için şimdiden teşekkür ederim

https://imgur.com/a/7neml0o