Messages

Update: im regarded :(
forgot to change the default gateway on my nginx server

Update:
Port forwarding works from LAN network. Nmap results show ports open on firewall local IP and public IP, yet it's unreachable from outside of my local network. Configuration same as before but now with This Firewall as destination.

I interpreted that line as destination from router to the server. That's fixed my problem :) thank u

Hi all,

I've set up my OPNsense 24.7 router this morning. I've been trying to setup port forwarding on my router so I can get my reverse proxy to work. The reverse proxy server is on my LAN. I bridged a 4 port NIC to use the LAN interface. WAN is configured on VLAN 6, with PPPoe. The VLAN is connected to a physical port.

Now for the port forwarding rule I tried to setup.

Code Select Expand

Interface: WAN
Protocol: TCP
Source: any
Source port: any
Destination: LAN address
Destination port range: 443
Redirect target IP: IP of Nginx rev proxy server on LAN subnet
Redirect target port: 443
NAT reflection: Enable
Filter rule association: Rule

Under Firewall > Rules > WAN I can see the firewall rule has been automatically created

Under Firewall > Settings > Advanced the following relevant settings are enabled:

Code Select Expand

Reflection for port forwards: ON
Reflection for 1:1: OFF
Automatic outbound NAT for Reflection: ON

My theory is that it has something to do with WAN being on VLAN 6? NAT works just fine though.
The port is unreachable from inside as well as outside my network.

Interfaces > Diagnostics > Port Probe shows the port on my Nginx server as open on TCP.

Desperate for any suggestions, I've tried all the guides I can find. Thanks