1
General Discussion / Problems setting up second LAN Interface
« on: October 30, 2024, 09:22:01 pm »
I have installed Version24.7.5 with a single WAN and LAN interface and it is working fine. the machine that it is installed on has a second set of interfaces (SFP+) that I decided to use for a higher speed connection for the kids gaming computors.
I created a new interface LAN2 (Static IP set to x.x.x.2 LAN static IP x.x.x.1 and enabled it, looked ok seemed to be working, I then enables the DHCP on LAN2 and updated the DHCP for LAN & LAN2 with different ranges (LAN x.x.x.10 to x.x.x.110 and LAN2 x.x.x.111 to x.x.x.210).
This resulted in all the connected devises when their DHCP lease expired being given a new IP adress in the 111 to 210 range and the gateway x.x.x.2 irrespetive of what port they were physically connected to. As there were no Firewall rules for LAN2 this led them to being disconnected
What have I done wrong ? is this the best way to setup 2 Lan interfaces or was I trying to do something fundementally wrong ?
Thanks
I created a new interface LAN2 (Static IP set to x.x.x.2 LAN static IP x.x.x.1 and enabled it, looked ok seemed to be working, I then enables the DHCP on LAN2 and updated the DHCP for LAN & LAN2 with different ranges (LAN x.x.x.10 to x.x.x.110 and LAN2 x.x.x.111 to x.x.x.210).
This resulted in all the connected devises when their DHCP lease expired being given a new IP adress in the 111 to 210 range and the gateway x.x.x.2 irrespetive of what port they were physically connected to. As there were no Firewall rules for LAN2 this led them to being disconnected
What have I done wrong ? is this the best way to setup 2 Lan interfaces or was I trying to do something fundementally wrong ?
Thanks