"
Indeed your fix got it going. Thanks for posting the solution.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Hardware and Performance / Re: HP T740 thin client does not boot installer disks - atkbd0: [GIANT-LOCKED]
December 29, 2024, 01:49:05 AM #2
Hardware and Performance / Re: HP T740 thin client does not boot installer disks - atkbd0: [GIANT-LOCKED]
November 18, 2024, 07:48:51 AM
I encountered this error today setting up a T740 with the latest OPN.
#3
General Discussion / Re: Internet access down yet OPNsense seems fine
October 24, 2024, 09:23:28 PM
Following.
I am also running OPN bare metal and three instances where I seem to lose internet after about 10ish days of uptime. Running OPN with Adguardhome DNS.
OPN host LAN ip responds to pings but cannot access the GUI nor ssh to the box. When it happened yesterday I could traceroute/ping to 8.8.8.8 so it seems DNS service went down. I've had to hard reboot the box. WAN is on the onboard Realtek (using realtek driver) and an Intel 4 port I340 nic.
I have a monitor and keyboard attached to it now so I can check the next time this occurs.
I am also running OPN bare metal and three instances where I seem to lose internet after about 10ish days of uptime. Running OPN with Adguardhome DNS.
OPN host LAN ip responds to pings but cannot access the GUI nor ssh to the box. When it happened yesterday I could traceroute/ping to 8.8.8.8 so it seems DNS service went down. I've had to hard reboot the box. WAN is on the onboard Realtek (using realtek driver) and an Intel 4 port I340 nic.
I have a monitor and keyboard attached to it now so I can check the next time this occurs.
#4
General Discussion / Re: AdGuard Home + Unbound + DHCP all on one Opnsense install
October 23, 2024, 08:57:14 PM
I'm a newcomer to Opnsense so take it with a grain of salt. I'm recently set up Opnsense on bare metal with AGH on port 53 and unbound on xxx53, essentially AGH > Unbound. In Opnsense, I added a static IP to the client that wants ads. Then in the AGH > Settings > Client settings, add a persistent client: in the Identifier, enter that clients static IP and under Protection, uncheck Use global settings. This should allow that client to passthrough your AGH.
Pages1
