Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - siwilson

#1
Thanks I did previously check that list but couldn't see my specific adapter. However, I know that somehow that SSD must be supported by freeBSD because I have an identical setup running pfsense. But, I got a pre-built image for that one so did not have to install it. There is no other adapter available other than USB as I mentioned.
#2
As per title. I am an opnsense N00b but come from a limited knowledge of pfsense running on the same hardware.
I successfully booted a live version of opensense from usb, then tried using the installer account to install on the local SSD. I could not get it to recognise/mount the drive. I then tried an SATA to usb adapter, and the installer can see the SSD so I installed opensense there. I installed the SSD back into its slot and it does successfully boot as far as the point of trying to mount the root directory, which then fails.

Any ideas what I may be doing wrong or tips on what to try?

I believe this is the SATA controller: 00:11.0 SATA controller: Advanced Micro Devices, Inc. [AMD] FCH SATA Controller [AHCI mode] (rev 40) (this info from https://www.parkytowers.me.uk/thin/wyse/d/dx0q/)

TIA