Messages

Hi

I just enabled EAP on FreeRadius, I generated a client certificate under Trust -> Certificates and tried to download and import this certificate (p12) into Keychain Access in macOS. It fails even though I enter the exact same password in the import dialog stating "Invalid password". I found in a forum another user with the same problem but it was in september 2024 so I thought it might have been fixed? I just today downloaded the latest version of OPNSense

If I in the prompt do:
openssl pkcs12 -info -in test_cert.p12

Then it asks for password 3 times and it seem to accept my input. Seem like an issue between opnsense and macOS?
Is there a way to do this right ?

Hi

I am using the NUT plugin and have connected a UPS over usb to the opnsense router.

However as soon as the battery is low on the UPS it shuts down.
I do not want the opnsense router to shut down as it will not restart itself unless the battery gets completely empty. I do however have multiple other servers as clients to the opnsense nut service and I want these to shut down as usual.

Can I disable the shut down of the opnsense system but still run the nut service?

Thanks alot! That sounds like the best option so far

I have set up a VLAN for a Device network for mobile phones. These should only be able to access Internet and a single IP address on LAN (10.0.10.223).

I like to set up rules in the wat that I define what to allow, and not defining what not to allow. However this is the only way I have found to set this up (see attached picture)

Is it possible to define this the other way around, only defining what is allowed?