1
General Discussion / Re: Opnsense defaulting to modem management port on WAN weekly
« on: October 05, 2024, 02:59:03 am »
Thank you! I set it to ignore the management port IP, hoping this works.
G
G
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Opnsense defaulting to modem management port on WAN weekly
« on: October 05, 2024, 12:54:15 am »
I have a N100 fanless box set up with Opnsense installed, connected to an Arris SB8200 modem. I have LAGG enabled on both the modem, and as the WAN interface in Opnsense, both cables connected. This works fine during the week, I am able to pull 1200Mbps on a gigabit plan. However, every week on Sunday, without fail, the connection will reset, or is lost, and Opnsense will default to the management port on the modem (192.168.100.1) for internet, which causes me to lose internet access. Even when connection is restored, it won't switch to the appropriate address.
Is there a way to prevent Opnsense from failing over to the management port? Is this a lost cause?
Is there a way to prevent Opnsense from failing over to the management port? Is this a lost cause?
Pages: [1]