Show Posts
1
General Discussion / Can’t figure out how to set Subnet Mask
« on: July 09, 2024, 07:21:16 am »
I plugged my wan connection into my box, and I couldn’t get a connection to the internet so I contact my ISP and was told this.
You need to set the router's "Internet connection type" to "static IP", and apply the IP address information listed below. Let us know if you need any further assistance setting up the router.
IP- xx.xx.xxx.170
Subnet Mask- 255.255.255.240
Gateway- xx.xx.xxx.161
DNS 1- 10.1.1.3
DNS 2- 10.1.1.6
I’m not quite sure where the gateway and subnet mask options are but I’ve set the ipv4 address to static in my Interfaces > Wan
You need to set the router's "Internet connection type" to "static IP", and apply the IP address information listed below. Let us know if you need any further assistance setting up the router.
IP- xx.xx.xxx.170
Subnet Mask- 255.255.255.240
Gateway- xx.xx.xxx.161
DNS 1- 10.1.1.3
DNS 2- 10.1.1.6
I’m not quite sure where the gateway and subnet mask options are but I’ve set the ipv4 address to static in my Interfaces > Wan