Show Posts
1
General Discussion / Newbie Virtual IP NAT question
« on: May 21, 2024, 10:17:48 am »
Hey Guys,
I am quite new to OPNsense and looking in the documentation didn't help unfortunately.
I have a few virtual IP addresses set up supplied by my DC provider and I am trying to use one of them to Port forward to a VM I have set up.
I have added a Port forwarding rule as follows:
Interface: Wan
Proto: TCP/UDP:
Source: any
Destination: virtual IP
Ports: Port alias for ports
Redirect Target IP: 10.0.0.10
Interestingly when I try and access the server on port 22 for SSH it redirects to another host on the network 10.0.02, I can also RDP to a Windows VM on 10.0.0.3 I have set up using the external IP that should only redirect to the one host (10.0.0.10) and not the others.
I know this may be a tick box or something I have missed but for the life of me, I can not figure it out.
Thanks
I am quite new to OPNsense and looking in the documentation didn't help unfortunately.
I have a few virtual IP addresses set up supplied by my DC provider and I am trying to use one of them to Port forward to a VM I have set up.
I have added a Port forwarding rule as follows:
Interface: Wan
Proto: TCP/UDP:
Source: any
Destination: virtual IP
Ports: Port alias for ports
Redirect Target IP: 10.0.0.10
Interestingly when I try and access the server on port 22 for SSH it redirects to another host on the network 10.0.02, I can also RDP to a Windows VM on 10.0.0.3 I have set up using the external IP that should only redirect to the one host (10.0.0.10) and not the others.
I know this may be a tick box or something I have missed but for the life of me, I can not figure it out.
Thanks