Messages

Just wanted to pop back on and confirm that the multiple bridge interfaces worked well.

Thanks again.

I hadn't considered control plane vs data plane, I appreciate the insight! It's a very good point about line speed and using a managed switch.

The bridge(s) that you suggest is similar to what I attempted, but bricked the box.  ;D Certainly a misconfiguration on my end and will attempt again.

Thanks Patrick!

I've attached a diagram to understand the configuration a bit.

[GOAL:]

I've been reading through the forums (perhaps I didn't dig deep enough) and couldn't find an definitive answer on how to configure multiple trunk ports.

GOAL:
ETH 04 = tagged VLAN 10 & VLAN 20
ETH 03 = tagged VLAN 10 & VLAN 20
ETH 02 = untagged VLAN 10

VLAN10 = Internal
VLAN20 = Guest

I appreciate any advice on this!