Messages

Finally !!!

thank you so much it worked ;D

[OPNsense A]

Hi all,

I try to build a VPN tunnel with IPsec and VxLAN between 2 locations and bridge same IP subnet on both side.
At first i build a configuration like below and it worked just fine.

[PC 192.168.1.2]<->[192.168.1.1/24 Bridge OPT1+VxLAN][OPNsense A][OPT2 10.1.0.2/16]<->{ ipsec tunnel}-INTERNET-{ipsec tunnel}-[10.2.0.2/16 OPT2][OPNsense B][192.168.2.1/24 Bridge OPT1+VxLAN]<->[PC 192.168.2.2]

then I followed this instruction "Reply #4": https://forum.opnsense.org/index.php?topic=37182.msg182040#msg182040

[PC 192.168.1.3]<->[192.168.1.1/24 Bridge OPT1+VxLAN][OPNsense A][OPT2 10.1.0.2/16]<->{ ipsec tunnel}-INTERNET-{ipsec tunnel}-[10.2.0.2/16 OPT2][OPNsense B][192.168.1.2/24 Bridge OPT1+VxLAN]<->[PC 192.168.1.4]

it didn't worked

VxLAN edited like this on A:
Source address: 10.1.0.2
Remote address: 10.2.0.2

Hypervisor: Proxmox

Now I have few questions

1.

• Can it be the normal "IPsec"
• The VTI route based https://docs.opnsense.org/manual/how-tos/ipsec-s2s-route.html

or doesn't matter?

2.Does the OPNsense support such configuration, if yes, where is the mistake or where did i forgot something?

Thanks :)