Messages

Thanks that worked.
What is the difference between the DNS settings there, and the DNS settings under LAN --> ISC DCHPv4?

Hi,

When I disable unbound in opnsense my DNS queries do not resolve. I have an application on my PC that does not connect to the internet when using unbound, so don't want to use it.

Under services --> LAN --> ISC DCHPv4, I have 8.8.8.8 as my DNS.
How can I switch to using that DNS when unbound is disabled?

Fixed it, if anyone has a similar issue I did this:
Exported backup config to XML and searched for adguard (this is after it was deleted from the plugins).
Found a small codeblock of adguard with version 0.1.1, it wasn't enabled (boolean value was 0) but deleted the code block anyway.
Restored the edited config and rebooted. Unbound had started (as it usually did after a reboot), but it started again after manually stopping it, which didn't previously work.

Still can't get it to work.
Managed to get the adguard plugin working and showing in the UI, and it's definitely disabled but unbound still won't start because of adguard using the port. It's like there's another version installed somewhere that's running in the background.

Interestingly whenever I upgrade to a new version (just upgraded to 24.1.2 10 mins ago) unbound will start on its own fine. But if I stop it, then try to start it again, it won't start, with adguard apparently using the port.
Very confusing.

If I try to install it again, it appears to install, then I go to Services and there's no Adguard menu. Also when I go back to plugins it shows as not installed.
Can I kill the service then delete it manually via the terminal?

Thanks guys. It shows as "command AdGuardHom".
I thought I had disabled Adguard completely. When I look in plugins it shows as available but it doesn't look like it's installed. There is no recycle bin next to the package like there is for the other two that I have installed (home assistant and zerotier).
How can I remove it completely?

Hi all,
Bit of a PFSense noob here, but since updating several revisions to version 24.1.1, Unbound does not start either through the CLI or the web interface.

See error below:
root@OPNsense:~ # unbound -c /var/unbound/unbound.conf
[1709101468] unbound[28577:0] error: bind: address already in use
[1709101468] unbound[28577:0] fatal error: could not open ports

How can I find out what is using port 53? It will start fine when set to anything else. OpenDNS is not running, and neither is Dnsmasq.

Thank you