"
Hello,
I have 1 wireguard instance running under port 51820 and with endpoints assigned as 51820. Devices work great
Both wireguard interfaces are assigned ,Firewall Rules for both firewalls to allow
IPv4+6 * * * * * * * AllowAll-WireGuard
Firewall WAN rules
IPv4+6 UDP * * WAN address 51820 * * WireGuardVPN
IPv4+6 UDP * * WAN address 53 (DNS) * * WireGuardDNS53
Nat Outbound set as Automatic outbound NAT rule generation
(no manual rules can be used)
I created another wireguard instance simulating the wireguard that i had setup with with listen port and client endpoint ports of 123,53 however when looking on the client end seeing under Transfer seeing rx as 0 and tx numbers increasing
Any insight would be appreciated as to what could i be missing
I have 1 wireguard instance running under port 51820 and with endpoints assigned as 51820. Devices work great
Both wireguard interfaces are assigned ,Firewall Rules for both firewalls to allow
IPv4+6 * * * * * * * AllowAll-WireGuard
Firewall WAN rules
IPv4+6 UDP * * WAN address 51820 * * WireGuardVPN
IPv4+6 UDP * * WAN address 53 (DNS) * * WireGuardDNS53
Nat Outbound set as Automatic outbound NAT rule generation
(no manual rules can be used)
I created another wireguard instance simulating the wireguard that i had setup with with listen port and client endpoint ports of 123,53 however when looking on the client end seeing under Transfer seeing rx as 0 and tx numbers increasing
Any insight would be appreciated as to what could i be missing
