Messages

Hello.  I have a Protectli 4 port and configured interfaces at initial opnsense CLI install.  I've tried searching around for similar questions but nothing that I've found seems to be working.  I'd like to communicate between interfaces and I'm having a tough time getting it working.  For starters, I want to be able to connect to machines on an OPT interface (LAB) from computers on my LAN interface.  I've tried various any anys in and out on both interfaces to no avail... Thanks for any assistance. 

Ah yes thank you.  This worked.  I was misunderstanding the purpose of these packages in other discussions.  Thanks again.

Hey hey everyone.  Attempting to install opnsense baremetal on a beelink device with a dual realtek nic.  (yes, I realize that there are issues with realtek). 

When I start the installation it recognizes a wireless card but not the dual nic.  When I drop to a shell and run pciconf I can see the two interfaces but they are listed as none0 and none1.  Is this a matter of enabling or installing the realtek drivers?  I'm a bit confused as I can't find to many issues that are very similar.