"
Actually, I found the issue. Need to delete Hetzner native route.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Discussion / Re: Access to UI from WAN interface if you have only CLI access
October 11, 2023, 02:36:50 PM #2
General Discussion / Access to UI from WAN interface if you have only CLI access
October 11, 2023, 09:04:27 AM
Hi,
I installed opnsense on Hetzner cloud and trying to get access from WAN. I ip settings are correct have an access from firewall to the internet. I used "pfctl -d" to disable firewall but still I dont have an access. I checked filter logs and see that firewall is receiving traffic but it blocks it. Is there any way to allow an access from WAN using CLI? easyrule is also not working.
I installed opnsense on Hetzner cloud and trying to get access from WAN. I ip settings are correct have an access from firewall to the internet. I used "pfctl -d" to disable firewall but still I dont have an access. I checked filter logs and see that firewall is receiving traffic but it blocks it. Is there any way to allow an access from WAN using CLI? easyrule is also not working.
Pages1
