Messages

1

General Discussion / IPsec Trouble

« on: September 23, 2023, 04:40:49 pm »

I am new to opnsense. I have multiple houses connected with IPsec tunnels. I am having trouble with my IPsec rules. I am seeing blocked traffic in the firewall log however, I believe my rules are correct? I can ping, but I can't get any webpages or GUI's of remote devices to load normally. They either are very slow (like minutes) or load a very basic text GUI which is not correct. This is happening between all my site to site connections. I also created an all rule to attempt to narrow down the cause but it does not want to allow it still.

This setup was working previously with UniFi IPsec at both locations. I am slowly trying to switch over to OPNsense.

Any suggestions on a rule to match this traffic?