Messages

[As a note to developers, I would have appreciated if the GUI had all default values set shown below a setting input.]

Yes I did apply, also now enabled the default gateway, and even cleared the states table. Seems like disabling a single gateway network does not have any effect, or something else.

So I need to enable Far Gateway as my gateway IP is not in the same subnet as the IP provided by the internet provider.

When using policy-based routing, make sure to allow access to local DNS (see the docs).

I tried to replicate the settings in my PfSense... I am using port forwarding to 127.0.0.1 unbound, to be able to use another port for port forwarding in VPN DNS.

As a note to developers, I would have appreciated if the GUI had all default values set shown below a setting input.

Cheers.

I have three questions to better understand how the logic works of OPNSense interface coming from PfSense.

I have a PPPOE WAN and the disable button in the System/Gateways/Single does not work, but when I go edit and select disable, it shows Status/Pending... and the internet still works.

Can someone please explain me what Far Gateway is and what kind of situations I do need it?

Also when the gateway is enabled when I go to rules and add change the default gateway to WAN, the internet goes down. Policy routing does not work for single GW. Was working in PfSense. Do not know which one is better.

Thank you.