Messages

Thanks all.

Yes, I read about that realtek

Any suggestions on a small device or 1U short rack (~11inch deep) , about 50 devices, home-based office

Preference to somewhere with Free Shipping to Canada (like Amazon.ca, Newegg.ca )  ordered a case from plinkusa ... man that was a small fortune after shipping, duty ! 

em0_vlanxx vs vlanxx , assigned to re0 --- re0 needs to be live and listed --cannot be disabled or not show, Granted it does not need an interface configured ..but I get no response to the IP address on vlan19 in the new config -- it's like traffic is not getting through.

I am wondering because it is a bridged interface or if because the vlans were setup via Proxmox and not in Opnsense on the original; if they are referenced differently --  since they take on the interface name em0_ -- where manually I cannot do that in the OPNSense Other types , they need to be vlan0xx

I have one more interface for the LAN that I do not have in the Virtual -- if that makes sense.

Hi Community,

I've been running OpnSense off a Proxmox server for sometime, but want to move it down to small platform device, so I picked up a Beelink U59 device.

My restore experience was not fun, so I went from scratch.

re0 is LAN
re1 is WAN
I've added some vlan's via the opnsense to match the config I have (of sorts) in the old one.

The challenge is, nothing seems to work the same.

I believe it's because in the new opnsense, I have LAN (re0) where I do not because the creation of vlan's were created outside the OS and in proxmox -- like attached images

Witch port this lies on is Tag: 19,66   Untagged : none    PVID: 19

Thoughts?