1
24.1 Legacy Series / Re: 24.1.1 NTOPNG and REDIS no longer working
« on: March 27, 2024, 10:03:26 am »
Same issue. 24.1.4 - Redis and NtopNG Showed as "working services" but no access...
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
23.1 Legacy Series / Re: 23.1.11 update broke IPsec tunnels
« on: July 10, 2023, 12:06:10 pm »
Update (fixed)
Strange bug after all. What im did:
1) Disabled first local subnet in Phase 2;
2) Pushed to restart IPsec service;
3) Connected to VPN, checked this second network, which was unreachable, now it is reachable;
4) Disconnected;
5) Enabled first network in Phase 2;
6) Pushed to restart IPsec service;
7) Now "Status information" shows me that i have both networks access in Phase 2;
My laptop shows me both networks reachable...
Strange bug after all. What im did:
1) Disabled first local subnet in Phase 2;
2) Pushed to restart IPsec service;
3) Connected to VPN, checked this second network, which was unreachable, now it is reachable;
4) Disconnected;
5) Enabled first network in Phase 2;
6) Pushed to restart IPsec service;
7) Now "Status information" shows me that i have both networks access in Phase 2;
My laptop shows me both networks reachable...
3
23.1 Legacy Series / 23.1.11 update broke IPsec tunnels
« on: July 10, 2023, 11:52:21 am »
Good day, folks!
After updating to version 23.1.11, IPsec (IKEv2) started acting weird. I have configured in Tunnels, in the second phase, access to two internal subnets. Now after the update, only access to one subnet out of two works. And now what i can do?
Now, I'm looking at the connection status in the "Status Information" tab, and there, behind my connection, only one subnet is visible in the second phase!
After updating to version 23.1.11, IPsec (IKEv2) started acting weird. I have configured in Tunnels, in the second phase, access to two internal subnets. Now after the update, only access to one subnet out of two works. And now what i can do?
Now, I'm looking at the connection status in the "Status Information" tab, and there, behind my connection, only one subnet is visible in the second phase!
Pages: [1]