Messages

Was a RAM issue. Been running for a week without fail :). Thanks everyone!

Thanks for the thoughts and recommendations everyone. I am returning the RAM, as its covered by amazon(thanks Bezos). In terms of the N200, that's disappointing to hear the stability problems. I will try that command that was recommended, and hope for the best. Once again, thanks everyone, and I will reply to this thread once I get my new RAM, with hopefully good news!

Ran memtest86+ for 41:09 minutes and it detected 19 errors and 1 pass. I assume that means the memory's bad. memtest86+ recommends swapping one of the modules, but this is a one dimm system. I just got the ram, so should I just return in and replace it with a new one to be safe?

Downloading memtest86+

just for specs, im running and N200 with a 1x 16gb ddr5 4800mhz with a kingston 500gb ssd.

To note for the install of opnsense: When I was installing, I was trying to use the zfs version, but it kept failing, so i tried a few times and each time it would progress farther and then it finally worked. At the time, I just assumed it fixed whatever the issue was, but could that be the root of my problem?

Code Select Expand

trap number = 12
panic: page fault
cpuid = 0
time = 1688812201
KDB: stack backtrace:
db_trace_self_wrapper() at db_trace_self_wrapper+0x2b/frame 0xfffffe00c5cd1b20
vpanic() at vpanic+0x17f/frame 0xfffffe00c5cd1b70
panic() at panic+0x43/frame 0xfffffe00c5cd1bd0
trap_fatal() at trap_fatal+0x385/frame 0xfffffe00c5cd1c30
trap_pfault() at trap_pfault+0x4f/frame 0xfffffe00c5cd1c90
calltrap() at calltrap+0x8/frame 0xfffffe00c5cd1c90
--- trap 0xc, rip = 0xffffffff82f1f043, rsp = 0xfffffe00c5cd1d60, rbp = 0xfffffe00c5cd1da0 ---
ng_netflow_expire() at ng_netflow_expire+0x273/frame 0xfffffe00c5cd1da0
softclock_call_cc() at softclock_call_cc+0x13d/frame 0xfffffe00c5cd1e40
softclock() at softclock+0x79/frame 0xfffffe00c5cd1e60
ithread_loop() at ithread_loop+0x25a/frame 0xfffffe00c5cd1ef0
fork_exit() at fork_exit+0x7e/frame 0xfffffe00c5cd1f30
fork_trampoline() at fork_trampoline+0xe/frame 0xfffffe00c5cd1f30
--- trap 0x80d08f20, rip = 0xffffffff80c30e5f, rsp = 0, rbp = 0x2b56000 ---
mi_startup() at mi_startup+0xdf/frame 0x2b56000
KDB: enter: panic

Heres the part of the code,so you dont have to download that file

Hello, I just setup my OPNSense router yesterday, so a fresh install and only a theme plugin. For some reason, the router keeps crashing. Every time I check the crash reporter(its huge btw), I see something related to the attached messages on there. I am new to networking and this whole system, so any advice or anything else you guys might need to help me, feel free to ask and I will try my best to help