Messages

What are the best practices to avoid downtime caused by firmware upgrade of OPNsense?
My current setup is similar to 'Diagarm 1'. Is the solution sketched in 'Diagarm 2' good, or is there any better solution?

A "floating rule" works fine for vLANs but as you wrote it does not work for the router itself.
What is the suggested way to create the same rule for the router itself?

I have multiple gateways and multiple vLANs.
I would like to route the outgoing traffic through "gateway1" if the destination IP is "A.B.C.D" independently from the source of the traffic.
The source of the traffic could be any vLAN network or the router itself. 
What is the best way to implement a rule like this?

You could create 2 VLANs, one for "torrent" and one for "normal usage".
After this you could assign only the "broadband gateway" to your "torrent vLAN" in the "Firewall/Rules" rules.

You could use this tutorial also:

https://mullvad.net/en/help/using-pfsense-mullvad/