Messages

I have a failover wan group with my isp modem and a cellular modem.  My cellular modem is plugged into OPT1.  The cellular modem has an IP address of 192.168.5.1.  I would like to be able to access its configuration page even when it is not in use.  I tried to do this with an outbound Nat rule on the OPT1 interface.  Is this even possible since the default state is to use the normal wan interface?

I was able to fix it by adding the lan interface to the port forward.  Hopefully this doesn't create problems.

I just setup a dual wan group to use a failover cellular connection.  I also use dynamic dns which still updates properly. The issue I am having is when I try and access a service from inside the firewall using my dynamic dns address it doesn't connect, it doesn't work even if I use my external ip address from inside the firewall.  It still works from outside the firewall. 




 

I am having some trouble with this and a pi hole.  I set the firewall rule to send all traffic from port 53 to the pi-hole.  The pi-hole is set and the dns server in the opnsense settings.  When the firewall rule is enabled there is too much traffic to the pihole.  I think what is happening is the pihole is also sending queries out on port 53 which is getting bounced back to itself causing a never ending loop.