Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - dalibor

Pages1
#1
General Discussion / Re: Issue with connecting VM to Internet
February 13, 2023, 02:08:47 PM
Hi Demusman, thank you for reply...

I did what you said, I reset the OPNsense to factory defaults and stated from begining. I left the default settings and yes, I was able to connect to Internet from LAN, thank you for the tip.

However, the WAN interface was configured via DHCP, when I set fixed IP config with manually added gateway for WAN, I lost the connection to Internet again.

After some playing, I found out that for WAN interface I must explicitly set the gateway in the WAN configuration, previously it was set to Auto-Detect and this was it was not working.

Anyway, thank you very mush, problem solved.
Cheers!
#2
General Discussion / Issue with connecting VM to Internet
February 12, 2023, 05:08:13 PM
Hello all
After lot of searching and trying I decided to ask for help on this forum.

In short, I have VMware Worstation installed on my desktop PC (Linux Mint21) and there I have VM OPNsense and another VM "TestVM" in different subnet. The problem is that I cannot connect VM "TestVM" to internet.

I'll try to put here as much details as possible to have clear picture of the environment (please see attacment).

Router IP: 192.168.0.1
Desktop PC (physical): 192.168.0.100/24

VMware Workstation 16 PRO:
vmnet0 - Bridge: 192.168.0.0/24
vmnet8 - Host-Only: 192.168.1.0/24

OPNSense:
WAN interface connected to vmnet0 (Bridge), IP: 192.168.0.254/24, GW: 192.168.0.1
LAN interface connected to vmnet8 (Host-Only), : IP: 192.168.1.254/24

VM "TestVM":
IP: 192.168.1.6/24
GW: 192.168.1.254

I'm accessing the OPNsense management GUI on IP 192.168.1.254.

I created rule to pass from LAN to WAN and vice versa, played with gateways on LAN interface, I cannot get it to work.
I can ping the TestVM from my desktop PC - 192.168.0.100 -> 192.168.1.6.
I can ping the my desktop PC from TestVM - 192.168.1.6 -> 192.168.0.100.

However, I cannot ping the router from TestVM: 192.168.1.6 -> 192.168.0.1. Here in FW logs I see that the traffic is allowed, but I'm not getting ping response.
Also I cannot ping the OPNsense WAN interfase from my desktop PC (192.168.0.100 -> 192.168.0.254) and aslo from the router (192.168.0.1 -> 192.168.0.254 (same subnet)

I cannot figure it out what I'm doing wrong, so I really appreciate some help/advice.
Thank you in advance.






Pages1