1
General Discussion / Re: Wireguad RW Clients not able to access Hosts outside the local-LAN interface ...
« on: February 08, 2023, 03:20:03 pm »
Solved my problem to set the right NAT Outbound rules.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Wireguad RW Clients not able to access Hosts outside the local-LAN interface ...
« on: February 07, 2023, 01:17:58 pm »
Hello,
we are using a basic Wireguard-RW setup from the Knowledge Base.
The Problem: If we are connected via Wireguard we cannot access the Clients behind the Layer3 Switch and the Switch itself. It works well without Wireguard.
LAN-net: 172.10.10.254/24 (OPNSENSE)
Wireguard-net: 10.254.254.1/24
Layer-3-Switch: 172.10.10.1/24 and 192.168.1.1/24
My TEST's:
Best regards.
we are using a basic Wireguard-RW setup from the Knowledge Base.
The Problem: If we are connected via Wireguard we cannot access the Clients behind the Layer3 Switch and the Switch itself. It works well without Wireguard.
LAN-net: 172.10.10.254/24 (OPNSENSE)
Wireguard-net: 10.254.254.1/24
Layer-3-Switch: 172.10.10.1/24 and 192.168.1.1/24
My TEST's:
- Internet access OK!
- PING: LAN-net to 172.10.10.1 OK!
- PING: LAN-net to 192.168.1.1 OK!
- PING: Wireguard-net to 172.10.10.1, 172.10.10.200-202 NOT-OK!
- PING: Wireguard-net to 192.168.1.1, 192.168.1.100 OK!
Best regards.
Pages: [1]