"
Resolved issue.
Was related to NAT. Solution used was found here: https://forum.opnsense.org/index.php?topic=35464.0
Was related to NAT. Solution used was found here: https://forum.opnsense.org/index.php?topic=35464.0
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
24.7, 24.10 Series / Tailscale Connectivity Issues
December 30, 2024, 04:31:42 PM
Hi all,
Apologies in advance if this is a repeat but I could not find a reasonable answer to my specific problem when searching.
Since the release of the tailscale plugin I decided to drop my rpi node and run tailscale on opnsense.
The problem I am having is I am not able to connect to the remote network via tailscale.
TS status is running and I do have a tailscale IP. Under peer list I can see the remote node (although I cannot ping it's IP).
Other settings I did, which was similar to my rpi node is add a tailscale gateway and then a static route to the remote network (192.168.0.0/24) via the tailscale gateway but there is no connection.
It worked briefly after initial setup but now it isn't and there were no real changes done besides one upgrade to OPNSense.
Am I perhaps missing something in my setup?
Apologies in advance if this is a repeat but I could not find a reasonable answer to my specific problem when searching.
Since the release of the tailscale plugin I decided to drop my rpi node and run tailscale on opnsense.
The problem I am having is I am not able to connect to the remote network via tailscale.
TS status is running and I do have a tailscale IP. Under peer list I can see the remote node (although I cannot ping it's IP).
Other settings I did, which was similar to my rpi node is add a tailscale gateway and then a static route to the remote network (192.168.0.0/24) via the tailscale gateway but there is no connection.
It worked briefly after initial setup but now it isn't and there were no real changes done besides one upgrade to OPNSense.
Am I perhaps missing something in my setup?
#3
General Discussion / IPOE Support for WAN Connection
February 03, 2023, 08:38:05 AM
Hi all,
I've searched this forum and can't seem to find any solution to this. Many people asking but no answer whether it's possible, if it's in the pipeline or just not supported at all.
With that said, is it possible to setup the wan to use IPOE or has anyone got it working successfully with say just using static ipv4?
Thanks
I've searched this forum and can't seem to find any solution to this. Many people asking but no answer whether it's possible, if it's in the pipeline or just not supported at all.
With that said, is it possible to setup the wan to use IPOE or has anyone got it working successfully with say just using static ipv4?
Thanks
Pages1
