"
DISCLAIMER: The following action is not recommended as anyone can try to log onto your firewall admin GUI from the WorldWildWeb and you are inviting trouble. But, I am providing you the answer, assuming you understand there are better solutions to what you trying to achieve.
To enable Remote WebAdmin access from the WAN (outside world), do this:
One the Firewall GUI, goto:
Firewall -> NAT -> Port Forward -> Click the [ + ] sign to create a new rule as follows:
Interface: WAN
Protocol: TCP
Destination: WAN address
Destination Range: From: 443 (or HTTPS) -- -- To: 443 (or HTTPS)
Redirect target IP: "Single host or Network" and enter LAN IP of your firewall eg. 192.168.1.1
Redirect target port: 443 (or HTTPS)
See attached image of what the GUI would show if the rule was entered correctly. IP address for my OPNsense LAN is: 10.1.10.1
Save + Apply = JOY
Again... probably not the best idea, but there are times you need this to get things going initially.
To enable Remote WebAdmin access from the WAN (outside world), do this:
One the Firewall GUI, goto:
Firewall -> NAT -> Port Forward -> Click the [ + ] sign to create a new rule as follows:
Interface: WAN
Protocol: TCP
Destination: WAN address
Destination Range: From: 443 (or HTTPS) -- -- To: 443 (or HTTPS)
Redirect target IP: "Single host or Network" and enter LAN IP of your firewall eg. 192.168.1.1
Redirect target port: 443 (or HTTPS)
See attached image of what the GUI would show if the rule was entered correctly. IP address for my OPNsense LAN is: 10.1.10.1
Save + Apply = JOY
Again... probably not the best idea, but there are times you need this to get things going initially.
