Show Posts
1
Virtual private networks / Route48 WireGuard tunnel
« on: December 05, 2022, 12:59:25 pm »
Hi all!
New to opnsense but recently setup an s920 and looking to run v6 assignments through an r48 v6 tunnel which i used to do when i was running openwrt solely on an AP, however i used to achieve this through standard WG conf and IPv6-PD but now i can’t seem to set the same thing up using opnsense, anyone have any experience with this as i can’t seem to find any steps online regarding this
Thanks!
New to opnsense but recently setup an s920 and looking to run v6 assignments through an r48 v6 tunnel which i used to do when i was running openwrt solely on an AP, however i used to achieve this through standard WG conf and IPv6-PD but now i can’t seem to set the same thing up using opnsense, anyone have any experience with this as i can’t seem to find any steps online regarding this
Thanks!