"
Restarted OPNsense seem to have fixed it :)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
22.7 Legacy Series / Re: Firewall: Shaper - working when destination set to any but not on single IP
November 08, 2022, 12:33:08 PM #2
22.7 Legacy Series / Firewall: Shaper - working when destination set to any but not on single IP
November 08, 2022, 09:44:36 AM
Hello :)
I have a small problem, I am trying to set up bandwidth limiting on single IP's as I don't want to limit the entire interface but I can't get it to work.
When I set destination to any it limit my speed to 190-200Mbit/s but if I enter 192.168.1.3 which is the computer I am testing from it not working and I get +900Mbit/s.
Am I doing something wrong?
I have a small problem, I am trying to set up bandwidth limiting on single IP's as I don't want to limit the entire interface but I can't get it to work.
When I set destination to any it limit my speed to 190-200Mbit/s but if I enter 192.168.1.3 which is the computer I am testing from it not working and I get +900Mbit/s.
Am I doing something wrong?
Pages1
