"
Looks to be resolved now. Apparently Chrome keeps the connection open even if nothing is going on (probably some AJAX stuff going on). Anyhow, closed Chrome and re-opened, NAT is no longer taking place.
Thanks!
Ron
Thanks!
Ron
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
22.7 Legacy Series / NAT rule issue
October 27, 2022, 06:22:38 PM
All:
Is there a special or non-intuitive method needed to remove a NAT Port Forward rule?
I had a rule set up to route my WAN address port 8080 to an inside device. That was working just fine. I went to delete that rule (and yes, I did click the "Apply Changes" button) and while the UI reports that the rule is indeed gone, the firewall is still doing the port forwarding.
Thanks!
Ron
Is there a special or non-intuitive method needed to remove a NAT Port Forward rule?
I had a rule set up to route my WAN address port 8080 to an inside device. That was working just fine. I went to delete that rule (and yes, I did click the "Apply Changes" button) and while the UI reports that the rule is indeed gone, the firewall is still doing the port forwarding.
Thanks!
Ron
Pages1
