NAT rule issue

[rongage]

All:

Is there a special or non-intuitive method needed to remove a NAT Port Forward rule?

I had a rule set up to route my WAN address port 8080 to an inside device.  That was working just fine.  I went to delete that rule (and yes, I did click the "Apply Changes" button) and while the UI reports that the rule is indeed gone, the firewall is still doing the port forwarding.

Thanks!
Ron

[cookiemonster]

most likely an established connection, the firewall tracks them in the state table. You could clear them or wait for the connection to end. A new one won't be allowed.

[rongage]

Looks to be resolved now.  Apparently Chrome keeps the connection open even if nothing is going on (probably some AJAX stuff going on).  Anyhow, closed Chrome and re-opened, NAT is no longer taking place.

Thanks!

Ron