Messages

Hello,

is there a tutorial to integrate PiHole?

a) Docker/k3s-container on a server with IPv6 only and NAT64
b) IPv6 clients with SLAAC
c) IPv4 clients with KEA DHCP

No idea weather this should work.

Thanks. The IPv4 Web-GUI shows them "correct".

I meant probably all these leases ARE in the LAN interface. Can you tell for sure they belong anywhere else?

Thanks. I am now using SLAAC...

The DHCPv6 leases are coming from different interfaces:

HOME = ::10
IOT =  ::20

but it shows only LAN.

Many IoT devices only support SLAAC, if they support IPv6 at all.

Other than that, you have to select the correct RA mode to instruct devices to use DHCPv6 for all interfaces where you want it.

To me, it does not make much sense to use DHCPv6, even if you want to identify devices, because with IPv6 privacy extensions and randomized MACs these days, you cannot effectively do that anyway. Therefore, I prefer to use SLAAC only: https://forum.opnsense.org/index.php?topic=45822.0

Thanks. I will have a look at it...

Apparently there are no IPv6 leases on any other interface?

Thanks. The IPv4 Web-GUI shows them "correct".

The "Services: Kea DHCP: Leases DHCPv4" shows to which interface the IP-address is assigned.

The "Services: Kea DHCP: Leases DHCPv6" shows only "LAN" as interface.

Have I done something wrong?

Hello,

I have an IPv6 only network with Tayga installed.

It resolves github.com.

ping github.com
PING github.com (64:ff9b::8c52:7903) 56 Datenbytes
64 Bytes von 64:ff9b::8c52:7903: icmp_seq=1 ttl=52 Zeit=7.20 ms

curl https://github.com
works...

but not the IPv4!

ping 140.82.114.3
ping: connect: network not reachable

curl https://140.82.114.3
not working...

I do not want to install the IPv4 on this interface.

Is there a solution?

Is there a good "HOW TO" for newbies?

With IPv4 there was the possibilty to use the MAC-Address to access the a client.

DUID seems to be the solution, but I have not found any good reading...

Thank you.

The problem was somewhere else: k3s --> --flannel-ipv6-masq

curl -sfL https://get.k3s.io | INSTALL_K3S_EXEC="--write-kubeconfig-mode 644 --disable servicelb --disable traefik --default-local-storage-path /mnt/daten --cluster-cidr=2001:cafe:42::/56 --service-cidr=2001:cafe:43::/112 --flannel-ipv6-masq" sh -

Thanks for asking.

At the moment I am not able to monitor it.

I am trying to get ride of IPv4...

I shall investigate the topic later.

[fatal: unable to access 'https://github.com/pi-hole/pi-hole/';: Could not resolve host: github.com]

Hello,

I am trying to run IPv6 only on my local network.

I have installed Tayga and verified it with https://internet.nl/connection.

Everything seems to be okay.

I can access IPv4 pages (https://github.com/) but not download from there...

fatal: unable to access 'https://github.com/pi-hole/pi-hole/';: Could not resolve host: github.com

Where can I find more information about tuning WiFi-Calling (OPNsense 24.4.1_3-amd64)?

Today I had two calls disconnected without reason.